PDA

View Full Version : Help needed



Sethos
August 15th, 2013, 08:58
Hello,

I just bought a 1991 Pontiac Firebird, witch was ridiculously cheap (I just couldn't resist). Now, the previous owner had taken the car totally apart. He just couldn't figure out where all the parts where going an he decided to sell the car. Apparently I saved that little bird from being wrecked in a mud-race.

The car is in a very good condition. No rust, airco stil works, T-Tops are not leaking etc. with only 75tsnd original miles (!)

Now my question : Since I build already a KITT-Replica some years ago, I can figure out where all the parts are going, except for these :

2205

Does anyone know where these are going ? (2x, some foam weathersteip maybe??)

Thanks for any help.

Regards,
Ernest

aukc
August 15th, 2013, 23:45
hi Ernest, what are the dimensions of that gasket/seal?

Sethos
August 16th, 2013, 05:24
hi Ernest, what are the dimensions of that gasket/seal?

Hi Mike,

Outer Dimensions are : 9" x 8.2", inner dimensions : 7.08" x 6.2"
(Had to convert from cm to inch...hope I did this right)

Ernest