Activity Stream

I wish I had saw this. I have to start coming back on here.. I wonder how it went..

Did you have to press out the old ball joints. I've replaced them but I think they were replacements to begin with. The lower control arms all ready...

I've repaired holes in oil pans buy cleaning the area well, putting a small sheet metal screw into the hold and then covering it with quality epoxy...

Where is the convention this year? Thank you..

I just deleted all my spam again.. I wonder why this forum is not being taken care of... They had a real good thing going with the old forum but when...

Try adjusting the timing and give the engine what it wants. I would also remove the vacuum advance. That way you can bring the initial timing up...

Sold 3/2021

Same here!